Crankshaft Rear Oil Seal Protector EN-47839 U

SKU# EN-47839 U

California Residents: Warning

Reward Points You will earn 2 dollars off your next purchase for purchasing this product.

Item Condition: used

* Required Fields

Out of stock

Out of stock

Not sure if this is what you need? Give us a call and we'll look it up for free if you purchase the tools or parts from us!

Crankshaft Rear Oil Seal Protector EN-47839

Applications: High Feature V6 2.8L 3.0L 3.6L

Used with J-42183/EN-42183 or J-8092 Driver Handle.

The rear main seal is no longer supplied with an installation guide, and, due to the crankshaft bevel, installation without a guide will result in leaks. EN-47839 bolts to the rear of the crankshaft, and pilots the seal and housing into position. Because of the crankshaft bevel, the Driver Handle can be installed onto EN-47839 to hold it or remove it from the engine.

Manufacturer SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Brand SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Storage Code K-58

Warning: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm.

For more information go to www.P65Warnings.ca.gov.

Terms and Conditions

Used with J-42183/EN42183.

I understand that I'm about to purchase a Pre-Owned/Inspected tool. These are typically obtained from dealerships that close. Each piece has been hand-inspected by one of our in-house techs. These are guaranteed to be fully functional.

If you'd prefer to purchase a new tool, you can look at the right side of this page to see if we have any available.