(Heavy Duty Version of J-38868-A) Output Shaft Puller J-44467 U

SKU# J-44467 U

California Residents: Warning

Be the first to review this product

Reward Points You will earn 1 dollar off your next purchase for purchasing this product.

Item Condition: used

Out of stock

Not sure if this is what you need? Give us a call and we'll look it up for free if you purchase the tools or parts from us!

(Heavy Duty Version of J-38868-A) Output Shaft Puller J-44467 U Lower Gear Unit Assembly Remover and Installer

Applications: AZTEK w/4T65E, 4L60E, 4L80E, Medium Duty Truck, 2002 Buick Rendezvous, 2002 Chevrolet Venture (F4WD)

Used with J-6125-1B slide hammer to remove the output shaft from the transmission for proper service of the transmission. J-44467 grips the machine groove of the stub shaft to protect the spline from damage.

Manufacturer SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Brand SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Storage Code F-4

Warning: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm.

For more information go to www.P65Warnings.ca.gov.

Terms and Conditions

M10x1.5 Slide Hammer J-6125-1B is specially designed  by Kent-Moore for use with this puller. You will break the tool if you try to use a slide hammer longer than 18.5" because the angle has to change, putting the tool in a bind that it wasn't designed for.

I understand that I'm about to purchase a Pre-Owned/Inspected tool. These are typically obtained from dealerships that close. Each piece has been hand-inspected by one of our in-house techs. These are guaranteed to be fully functional. If you'd prefer to purchase a new tool, you can look at the right side of this page to see if we have any available.