DT-52506 Pinion Flange Holder and Remover Tool

SKU# DT-52506

California Residents: Warning

Be the first to review this product

Reward Points You will earn 4 dollars off your next purchase for purchasing this product.

Item Condition: new

$384.45

Out of stock

Not sure if this is what you need? Give us a call and we'll look it up for free if you purchase the tools or parts from us!

DT-52506 Pinion Flange Holder and Remover Tool

Application: 2019-later Silverado, Sierra with 8.0” ring gear front axles and with 9.5” or 9.76” ring gear rear axles

The pinion flange is held to the pinion using a nut with a very high torque and angle. The flange must be held precisely in order to accurately measure the angle when installing the nut, and must be held securely to remove the nut. DT-52506 fits the new flange spacing on 2019 truck axles, and will back-service all older flanges when removing or installing the pinion flange nut. DT-52506 includes the shoulder bolts required for 2019-newer truck axles, and can be used with the shoulder bolts from J-08614-A or J-08614-20 to service past models.

DT-52506 also includes an adapter to remove the flange once the nut is removed. The flange is removed (without removing the attachment fasteners) by installing the removal adapter through the center of DT-52506 and turning 1/8 turn to engage in the notches in the bottom of DT-52506. DT-52506 is then held while the removal screw is tightened against the pinion to remove the flange. DT-52506 can be used with a ½” square drive breaker bar, or with KM-956-1 Handle for higher torque applications.

Manufacturer SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Brand SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Storage Code S-77

Warning: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm.

For more information go to www.P65Warnings.ca.gov.