Flywheel Holding Tool EN-48018

SKU# EN-48018 D

California Residents: Warning

Be the first to review this product

Reward Points You will earn 8 dollars off your next purchase for purchasing this product.

Item Condition: used

$359.97

Out of stock

Not sure if this is what you need? Give us a call and we'll look it up for free if you purchase the tools or parts from us!

Flywheel Holding Tool EN-48018 U

Applications: 2006 STS-V

The flywheel must be held on-vehicle for various service procedures. The current flywheel holder is installed in place of the starter. On the LC3, this would require removing the supercharger. EN-48018 will hold the flywheel from the bottom, through the bell housing inspection hole. EN-48018 installs in place of two bell housing bolts, and engages the ring gear teeth to hold the flywheel. Unapproved methods may damage the flywheel.

Manufacturer SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Brand SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Storage Code L-61, R-73

Warning: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm.

For more information go to www.P65Warnings.ca.gov.

Terms and Conditions

I understand that I'm about to purchase a Pre-Owned/Inspected tool. These are typically obtained from dealerships that close. Each piece has been hand-inspected by one of our in-house techs. These are guaranteed to be fully functional.